31453
1.INSTALL CLUTCH MASTER CYLINDER PUSH ROD CLEVIS
Install the lock nut to the push rod.
| *1 | Lock Nut |
| *2 | Clutch Master Cylinder Push Rod Clevis |
Install the clutch master cylinder push rod clevis to the push rod.
Tighten the lock nut and check the dimension A is same as the dimension A that has been measured.
When tightening the lock nut, be sure to hold the clevis in place by its square portion.
31410
2.INSTALL CLUTCH MASTER CYLINDER ASSEMBLY
Apply MP grease to the contact surface of the clutch master cylinder push rod clevis and the clutch pedal sub-assembly.
|
MP grease |
Install the clutch master cylinder push rod clevis to the cutout of the clutch pedal sub-assembly from the left side of the vehicle and push it downward.
Install the clutch master cylinder assembly with the 2 nuts.
31481
3.CONNECT CLUTCH MASTER CYLINDER TO FLEXIBLE HOSE TUBE
Using a union nut wrench (10 mm), connect the clutch master cylinder to flexible hose tube to the clutch master cylinder assembly.
Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
31434
4.INSTALL CLUTCH RESERVOIR TUBE
Install the clutch reservoir tube to the clutch master cylinder assembly with the clip.
44610
5.INSTALL BRAKE BOOSTER ASSEMBLY
6.BLEED CLUTCH LINE
7.INSPECT FOR BRAKE FLUID LEAK
8.INSPECT BRAKE FLUID LEVEL
9.INSPECT AND ADJUST CLUTCH PEDAL