Home › Drivetrain › CLUTCH › CLUTCH RELEASE CYLINDER › from 2014.07
RM19S0E _52 Drivetrain _051467 CLUTCH _0248190 CLUTCH RELEASE CYLINDER A

CLUTCH  CLUTCH RELEASE CYLINDER  INSTALLATION  


PROCEDURE

Hide 31470 1.INSTALL CLUTCH RELEASE CYLINDER ASSEMBLY

a.

Install the clutch release cylinder assembly with the 2 bolts.

Torque:
12 N*m (120 kgf*cm, 9 ft.*lbf)


Hide 31482 2.CONNECT CLUTCH RELEASE CYLINDER TO FLEXIBLE HOSE TUBE

a.

Using a union nut wrench (10 mm), connect the clutch release cylinder to flexible hose tube to the clutch release cylinder assembly.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 3.FILL RESERVOIR WITH BRAKE FLUID

Hide 5.INSPECT FOR BRAKE FLUID LEAK