Home › Drivetrain › AXLE AND DIFFERENTIAL › STEERING KNUCKLE
RM19S0E _52 Drivetrain _051470 AXLE AND DIFFERENTIAL _0248210 STEERING KNUCKLE A

AXLE AND DIFFERENTIAL  STEERING KNUCKLE  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side as for the LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 43502E 1.INSTALL FRONT AXLE HUB BEARING

a.
U134585E01
2.104,1.478 2.396,1.494 false 2.414,1.405 2.601,1.586 0.187,0.180 10 *a 1.269,2.773 1.626,2.936 0.357,0.163 10 SST

Using SST and a press, insert a new axle hub bearing, with its magnetic rotor side facing the inside of the vehicle, until it reaches the end of the steering knuckle.

Text in Illustration
*a Magnetic Rotor Side
V100135

Inside of the vehicle

SST
09950-60020  (09951-00710)
09950-70010  (09951-07100)

NOTICE:
·

Do not remove the inner race because the hub bearing is built into the oil seal.

·

Do not use bearings that have been removed.

·

Do not wipe off any grease that has been applied to new bearings.

·

Do not bring magnets close to the magnetic rotor surface of the bearing.

·

Keep the magnetic rotor surface of the bearing free of foreign matter.




Hide 47782 2.INSTALL FRONT DISC BRAKE DUST COVER

a.
C243642E01
2.32,0.348 2.452,0.512 0.131,0.164 10 A 2.519,1.324 2.651,1.489 0.131,0.164 10 A

Provisionally install a new disc brake dust cover, as shown in the illustration.

Standard distance A:

19.8 mm (0.78 in.)



b.
C243001E01
2.443,0.439 2.800,0.602 0.357,0.163 10 SST 2.404,0.537 2.011,0.978 false

Using SST and a hammer, install the disc brake dust cover.

SST
09223-56010  

NOTICE:
·

Uniformly press in the disc brake dust cover while sliding SST slightly.

·

Press in the disc brake dust cover until it is securely seated to the pressing-in base.




c.
C107918

Using a chisel, fix the 3 points on the circumference.

NOTICE:

Securely fold each end into the engagement grooves.



Hide 43502C 3.INSTALL FRONT AXLE HUB SUB-ASSEMBLY

Hide 43502G 4.INSTALL FRONT AXLE HUB HOLE SNAP RING

Hide 5.INSTALL FRONT AXLE ASSEMBLY