Home › Suspension › ALIGNMENT / HANDLING DIAGNOSIS › REAR WHEEL ALIGNMENT › 2011.08–2014.07
RM19S0E _53 Suspension _051471 ALIGNMENT / HANDLING DIAGNOSIS _0248213 REAR WHEEL ALIGNMENT G

ALIGNMENT / HANDLING DIAGNOSIS  REAR WHEEL ALIGNMENT  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:

1.

Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>CALIBRATION).



PROCEDURE

Hide 3.INSPECT CAMBER

a.

Install the camber-caster-kingpin gauge and position the rear wheel on the alignment tester.


b.

Inspect the camber.

Camber (Unloaded Vehicle)
Model Tire Size Camber Right - Left Error
Except for Rough Road Package 175/70 R14 -0°57' +/- 30'
(-0.95° +/- 0.5°)
0°30'
(0.5°)
175/65 R15 -0°57' +/- 30'
(-0.95° +/- 0.5°)
0°30'
(0.5°)
175/65 R14 -0°57' +/- 30'
(-0.95° +/- 0.5°)
0°30'
(0.5°)
185/60 R15 -0°57' +/- 30'
(-0.95° +/- 0.5°)
0°30'
(0.5°)
Rough Road Package 175/65 R14 -0°54' +/- 30'
(-0.90° +/- 0.5°)
0°30'
(0.5°)
185/60 R15 -0°54' +/- 30'
(-0.90° +/- 0.5°)
0°30'
(0.5°)

NOTICE:

The tolerance for the difference between the left and right wheels is 30' (0.5°) or less for both cambers. If the camber is not within the specified range, inspect the suspension parts and replace them if necessary.



Hide 4.INSPECT TOE-IN

A166181E12
1.664,0.297 1.776,0.455 0.112,0.158 10 A 1.662,1.956 1.774,2.114 0.112,0.158 10 B

Text in Illustration
V100135

Front

Toe-in (Unloaded Vehicle)
Model Tire Size B - A
Except for Rough Road Package 175/70 R14 3.8 +/- 3.0 mm
(0.150 +/- 0.118 in.)
175/65 R15 3.8 +/- 3.0 mm
(0.150 +/- 0.118 in.)
175/65 R14 3.4 +/- 3.0 mm
(0.134 +/- 0.118 in.)
185/60 R15 3.6 +/- 3.0 mm
(0.142 +/- 0.118 in.)
Rough Road Package 175/65 R14 2.7 +/- 3.0 mm
(0.106 +/- 0.118 in.)
185/60 R15 2.8 +/- 3.0 mm
(0.110 +/- 0.118 in.)

If the toe-in is not within the specified range, inspect the suspension parts and replace them if necessary.