48069
1.TEMPORARILY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH
Provisionally tighten the front lower suspension arm sub-assembly LH with the 2 bolts.
Install the front lower suspension arm sub-assembly LH onto the steering knuckle with a new castle nut.
If the holes for the clip are not aligned, tighten the nut by a further turn of up to 60°.
Install a new clip.
2.INSTALL FRONT WHEEL
3. STABILIZE SUSPENSION
Lower the vehicle from the jack.
Bounce the vehicle up and down several times to stabilize the suspension.
48069
4.FULLY TIGHTEN FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH
Fully tighten the 2 bolts.
51405A
5.INSTALL ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)
6.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT