1. POSITION FRONT WHEELS FACING STRAIGHT AHEAD
45259A
2.REMOVE COLUMN HOLE COVER SILENCER SHEET
45209
3.SEPARATE STEERING SLIDING YOKE SUB-ASSEMBLY
Use a seat belt to fix the steering wheel assembly, in order to avoid breakage of the spiral cable.
Place matchmarks on the steering sliding yoke sub-assembly and the steering gear assembly.
| *1 | Steering Sliding Yoke Sub-assembly |
| *a | Matchmark |
Loosen bolt A, remove bolt B and separate the steering sliding yoke sub-assembly from the steering gear assembly.
45025D
4.SEPARATE NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY
Remove clip A, separate clip B from the body and separate the No. 1 steering column hole cover sub-assembly.
Do not damage clip B.
5.REMOVE FRONT WHEEL
51405A
6.REMOVE ENGINE UNDER COVER SUB-ASSEMBLY (for Metal Type)
48810
7.SEPARATE FRONT STABILIZER LINK ASSEMBLY LH
Remove the nut and separate the stabilizer link assembly LH from the front stabilizer bar.
Using a socket hexagon wrench 6 to hold the stud.
48820B
8.SEPARATE FRONT STABILIZER LINK ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
45047
9.SEPARATE TIE ROD END SUB-ASSEMBLY LH
45046
10.SEPARATE TIE ROD END SUB-ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
48069
11.SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH
48068
12.SEPARATE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
13.SUSPEND ENGINE ASSEMBLY (for Automatic Transaxle)
On a flat location, set the attachment, plate lift attachment, and wooden block in the positions shown in the figure, and set the engine assembly.
|
Attachment Placement Positions |
Set the engine assembly with transaxle so that it is horizontal.
Never attach the attachment and plate lift attachment to the oil pan section of the automatic transaxle.
14.SUSPEND ENGINE ASSEMBLY (for Manual Transaxle)
On a flat location, set the attachment, plate lift attachment, and wooden block in the positions shown in the figure, and set the engine assembly.
|
Attachment Placement Positions |
Set the engine assembly with transaxle so that it is horizontal.
Never attach the attachment and plate lift attachment to the oil pan section of the manual transaxle.
51201
15.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
Remove the bolt and separate the engine moving control rod.
Place wooden blocks or plate lift attachments in the positions shown in the illustration and set an engine lifter underneath the front suspension crossmember sub-assembly.
|
Front of the Vehicle |
|
Attachment Placement Positions |
Place the wooden blocks or plate lift attachments so that the front suspension crossmember sub-assembly is level.
As the front suspension crossmember sub-assembly is very heavy, be sure to support it securely.
Remove the 6 bolts and front suspension crossmember sub-assembly.
45510
16.REMOVE MANUAL STEERING GEAR
48829A
17.REMOVE FRONT NO. 1 STABILIZER BRACKET LH
48824A
18.REMOVE FRONT NO. 1 STABILIZER BRACKET RH
Use the same procedure for the RH side as for the LH side.
48811
19.REMOVE FRONT STABILIZER BAR
48069
20.REMOVE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY LH
Remove the bolt and the front lower suspension arm sub-assembly LH.
48068
21.REMOVE FRONT LOWER SUSPENSION ARM SUB-ASSEMBLY RH
Use the same procedure for the RH side as for the LH side.
12363A
22.REMOVE ENGINE MOVING CONTROL ROD
Remove the bolt and the engine moving control rod.