The skid control ECU (brake actuator assembly) is connected to the combination meter via CAN communication.
Pressing the VSC OFF switch turns off traction control and pressing and holding this switch turns off traction and VSC controls. If traction control turns OFF, the TRC OFF indicator light will come on.
If VSC and traction control turns OFF, the TRC OFF indicator and VSC OFF indicator light will come on.
The VSC OFF indicator light is illuminated when the VSC and TRC controls are prohibited by operating the VSC OFF switch.
By pressing the VSC OFF switch for 3 seconds or longer, the VSC OFF mode is activated, the VSC and TRC controls are prohibited, and both the VSC OFF indicator light and the TRC OFF indicator light in the combination meter are illuminated.
When replacing the brake actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)>CALIBRATION).
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
OK
NG
A
B
A
B
C
OK
NG
OK
NG
NEXT
Connect the intelligent tester to the DLC3.
Perform Active Test of the combination meter assembly using the intelligent tester (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).
The VSC OFF indicator light turns on or off in accordance with the intelligent tester.
OK
NG
OK
NG
OK
NG