Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor) › from 2014.07
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248227 VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Built-in Type Yaw Rate Sensor)  C1203  ECM Communication Circuit Malfunction  


DESCRIPTION

The circuit is used to send TRC and VSC control information from the skid control ECU (brake actuator assembly) to the ECM, and engine control information from the ECM to the skid control ECU (brake actuator assembly) through the CAN communication system.

DTC No. DTC Detection Condition Trouble Area
C1203 Engine, drive source and destination variations that are sent from the ECM do not match the ones of the skid control ECU (brake actuator assembly).
·

ECM

·

Skid control ECU (Brake actuator assembly)



PROCEDURE

1.CHECK PART NUMBER (ECM AND BRAKE ACTUATOR ASSEMBLY)
a.

Check that the proper ECM is installed.


Result
Result Proceed to
Proper ECM is installed A
Proper ECM are not installed (for 1NZ-FE) B
Proper ECM are not installed (for 2NZ-FE) C


A

2.CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)

B

C

2.CHECK BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)
a.

Check if the skid control ECU (brake actuator assembly) had been replaced before the DTC was recorded.

Result
Result Proceed to
The brake actuator assembly is not replaced A
The brake actuator assembly is replaced B



A

3.RECONFIRM DTC

B

4.PERFORM INITIALIZATION AND CALIBRATION
4.PERFORM INITIALIZATION AND CALIBRATION

NEXT

5.RECONFIRM DTC