1.DRAIN BRAKE FLUID
Immediately wash off any brake fluid that comes into contact with any painted surfaces.
28800
2.REMOVE BATTERY
74431
3.REMOVE BATTERY TRAY
74411
4.REMOVE BATTERY CARRIER
Disengage the 6 wire harness clamps and separate the wire harness from the battery carrier.
Remove the 5 bolts and the battery carrier.
44510
5.REMOVE BRAKE ACTUATOR ASSEMBLY (w/o VSC)
Release the lock lever and disconnect the brake actuator connector.
| *1 | Lock lever |
Be careful not to allow brake fluid to enter the removed connector.
| *a | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
| *b | From 1st Chamber of Brake Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Use tags or make a memo to identify the places to reconnect the brake tubes.
Using a union nut wrench 10 mm, separate the 6 brake tubes from the brake actuator assembly.
Remove the 3 bolts and brake actuator with bracket from the side member.
Do not damage the brake tubes or wire harness.
44510
6.REMOVE BRAKE ACTUATOR ASSEMBLY (w/ VSC)
Release the lock lever and disconnect the brake actuator connector.
| *1 | Lock lever |
Be careful not to allow brake fluid to enter the removed connector.
| *a | From 2nd Chamber of Brake Master Cylinder Sub-assembly |
| *b | From 1st Chamber of Brake Master Cylinder Sub-assembly |
| *c | To Front Wheel Cylinder Assembly LH |
| *d | To Rear Wheel Cylinder Assembly RH |
| *e | To Rear Wheel Cylinder Assembly LH |
| *f | To Front Wheel Cylinder Assembly RH |
Use tags or make a memo to identify the places to reconnect the brake tubes.
Using a union nut wrench 10 mm and union nut wrench 12 mm, separate the 6 brake tubes from the brake actuator assembly.
|
Flare Nut 10 mm |
|
Flare Nut 12 mm |
Remove the 3 bolts and brake actuator with bracket from the side member.
Do not damage the brake tubes or wire harness.
44590
7.REMOVE BRAKE ACTUATOR BRACKET ASSEMBLY
Remove the 3 bolts and brake actuator bracket assembly.
44546A
8.REMOVE BRAKE ACTUATOR BOLT CUSHION
Remove the 3 brake actuator case collars from the brake actuator bolt cushion.
Remove the 3 brake actuator bolt cushions from the brake actuator bracket assembly.