Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › REAR SPEED SENSOR
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248231 REAR SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  REAR SPEED SENSOR  REMOVAL  


PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 42403 2.REMOVE REAR BRAKE DRUM SUB-ASSEMBLY

Hide 89516D 3.DISCONNECT SKID CONTROL SENSOR WIRE

C107565

a.

Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.


Hide 42450B 4.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C236427

Remove the 4 bolts and remove the rear axle hub and bearing assembly from the axle beam.

NOTICE:

Suspend the backing plate with a piece of rope.


HINT:

The rear speed sensor is a component of the rear axle hub and bearing assembly. If the sensor malfunctions, replace the rear axle hub and bearing assembly.