Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248232 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 84306 1.INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

a.

Check that the ignition switch is turned off.


b.

Check that the negative battery terminal is detached.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Check that the front tires face straight forward.


d.

Check that the turn signal switch is in the neutral position.

NOTICE:

Perform the operation when the turn signal switch is in the neutral position. Otherwise, the turn signal pin will break.



e.

Engage the 3 claws and install the spiral cable with sensor sub-assembly.

NOTICE:

Pull the lock pin out before installing the steering wheel when replacing the spiral cable with sensor sub-assembly with a new one.



f.

Connect the steering sensor connector to the spiral cable with sensor sub-assembly.


g.

Connect the airbag connector to the spiral cable with sensor sub-assembly.


h.

Connect the horn connector to the spiral cable with sensor sub-assembly.


Hide 45100 5.INSTALL STEERING WHEEL ASSEMBLY

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)