Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248232 STEERING ANGLE SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  STEERING ANGLE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 45100 3.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 4.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 5.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 6.REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

a.
B282624E01
0.757,2.736 1.099,2.59 false 1.103,2.529 1.294,2.682 0.190,0.153 10 *1

Disconnect the horn connector from the spiral cable with sensor sub-assembly.


b.

Slide the slider and disconnect the airbag connector from the spiral cable with sensor sub-assembly.

Text in Illustration
*1 Slider

NOTICE:

When disconnecting the airbag connector, take care not to damage the airbag wire harness.



c.

Disconnect the steering sensor connector from the spiral cable with sensor sub-assembly.


d.
B282625

Disengage the 3 claws and remove the spiral cable with sensor sub-assembly.

NOTICE:
·

Do not replace the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Do not rotate the spiral cable sub-assembly when the ignition switch is ON and the battery cable is connected.

·

Make sure the steering wheel is installed and centered before rotating the steering angle sensor when performing steering angle sensor operation inspections (inspecting for abnormal noise, diagnosis inspections, etc.).

·

Do not remove the steering angle sensor from the spiral cable sub-assembly.

·

If there is a malfunction in the steering angle sensor, replace the spiral cable sub-assembly with steering angle sensor.