Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)
RM19S0E _54 Brake _051475 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0248235 VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor) C

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)  C1290  Steering Angle Sensor Zero Point Malfunction  


DESCRIPTION

The skid control ECU (brake actuator assembly) acquires steering angle sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point.

If front wheel alignment or steering wheel position is adjusted without disconnecting the negative battery terminal, or if yaw rate and deceleration sensor zero point is not acquired after the adjustments have been completed, the skid control ECU (brake actuator assembly) detects the difference between the previous zero point and newly acquired zero point and outputs this DTC to indicate a poor adjustment.

The steering angle sensor zero point malfunction warning will be cancelled by turning the ignition switch off.

DTC No. DTC Detection Condition Trouble Area
C1290 The steering angle sensor zero point calibration position vastly differs from the recorded value.
·

Yaw rate and deceleration sensor zero point calibration incomplete

·

Poor adjustment of the centered position of the steering wheel

·

Poor adjustment of front wheel alignment



CAUTION / NOTICE / HINT

NOTICE:

When replacing the brake actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).


PROCEDURE

1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND DECELERATION SENSOR
a.

Perform zero point calibration of the yaw rate and deceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM(for Separate Type Yaw Rate Sensor)>CALIBRATION).

HINT:
·

When the stored zero point of the yaw rate and deceleration sensor is cleared, the steering angle sensor zero point will also be cleared.

·

If the zero point and output value of the yaw rate and deceleration sensor and the output value of the speed sensors are not normal, steering angle sensor zero point cannot be acquired normally even if the vehicle is driven straight ahead at 35 km/h (22 mph) or more.





NEXT

2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION
2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION
a.

Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.


b.

Check that the centered position of the steering wheel is correctly set while driving straight ahead.

HINT:

If front wheel alignment and steering position are adjusted as a result of abnormal centered position of the steering wheel, acquire the yaw rate and deceleration sensor zero point again after the adjustments are completed.


OK:

The centered position of the steering wheel is correctly set.




OK

END

NG

ADJUST FRONT WHEEL ALIGNMENT OR STEERING POSITION