Home › Brake › BRAKE (FRONT) › FRONT BRAKE FLEXIBLE HOSE › from 2014.07
RM19S0E _54 Brake _051477 BRAKE (FRONT) _0248246 FRONT BRAKE FLEXIBLE HOSE A

BRAKE (FRONT)  FRONT BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 47313A 1.INSTALL FRONT BRAKE FLEXIBLE HOSE

a.

Install the flexible hose with a new union bolt and a new gasket.

Torque:
30 N*m (310 kgf*cm, 22 ft.*lbf)

HINT:

Install the flexible hose lock securely into the lock hole in the disc brake cylinder.



b.

Install the flexible hose and speed sensor with the bolt.

Torque:
29 N*m (300 kgf*cm, 22 ft.*lbf)

NOTICE:

Install the flexible hose and speed sensor without twisting them.



c.

Install the flexible hose with a new clip.


d.

Using a union nut wrench 10 mm, install the brake tube to the flexible hose while holding the flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 2.BLEED BRAKE LINE

Hide 3.BLEED CLUTCH LINE (for Manual Transaxle)

Hide 4.INSTALL FRONT WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)