Home › Brake › BRAKE (REAR) › REAR BRAKE FLEXIBLE HOSE › from 2014.07
RM19S0E _54 Brake _051478 BRAKE (REAR) _0248248 REAR BRAKE FLEXIBLE HOSE A

BRAKE (REAR)  REAR BRAKE FLEXIBLE HOSE  INSTALLATION  


PROCEDURE

Hide 47319F 1.INSTALL REAR FLEXIBLE HOSE

a.

Install the rear flexible hose with 2 new clips.

NOTICE:

Install the clip as far as it will go.



b.

Using a union nut wrench 10 mm, connect the 2 brake tubes to the rear flexible hose while holding the rear flexible hose with a wrench.

Torque:
15 N*m (155 kgf*cm, 11 ft.*lbf)

NOTICE:

Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).



Hide 2.BLEED BRAKE LINE

Hide 3.BLEED CLUTCH LINE (for Manual Transaxle)

Hide 4.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)