Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM19S0E _55 Steering _051480 POWER ASSIST SYSTEMS _0248253 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1552  PIG Power Supply Voltage Malfunction  C1554  Power Supply Relay Failure  


DESCRIPTION

When a problem occurs in the system, the power source relay circuit and the motor relay circuit are shut off to stop the power assist. The ECU must be replaced when there is a problem with the relays because each relay is built into the ECU.

DTC No. DTC Detection Condition Trouble Area
C1552 PIG power source circuit malfunction
·

EPS fuse

·

ALT fuse

·

PIG power source circuit

·

Power steering ECU assembly


C1554 Power source relay circuit malfunction
·

EPS fuse

·

ALT fuse

·

PIG power source circuit

·

Power steering ECU assembly



WIRING DIAGRAM

C239972E01
1.262,1.818 1.738,1.970 0.476,0.152 10 Battery 1.139,1.197 1.450,1.367 0.311,0.170 10 ALT 2.728,0.777 3.033,0.917 0.305,0.141 10 EPS 4.497,0.623 4.765,0.767 0.268,0.144 10 PIG 4.17,0.61 4.442,0.758 0.272,0.148 10 A42 4.253,0.439 4.359,0.585 0.106,0.146 10 1 4.497,1.638 4.920,1.782 0.424,0.144 10 PGND 4.17,1.625 4.442,1.773 0.272,0.148 10 A42 4.253,1.454 4.359,1.600 0.106,0.146 10 2 4.377,2.176 6.354,2.324 1.977,0.148 10 Power Steering ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:
·

If the power steering ECU assembly has been replaced, perform the torque sensor zero point calibration and assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).

·

Inspect the fuses for circuits related to this system before performing the following inspection procedure.



PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER (PIG POWER SUPPLY)
a.

Turn the ignition switch off.


b.

Connect the intelligent tester to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the tester on.


e.

Enter the following menus: Chassis / EMPS / Data List.


f.

Select the item PIG Power Supply in the Data List and read the value displayed on the tester.

EMPS
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
PIG Power Supply Power source voltage to activate motor/
Min.: 0.0000 V
Max.: 20.1531 V
11 to 14 V The engine is running and power steering is operating



OK

NG

2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND)
2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND)

A

REPAIR OR REPLACE HARNESS OR CONNECTOR

B

REPLACE POWER STEERING ECU ASSEMBLY

C

REPLACE POWER STEERING ECU ASSEMBLY