Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER › 2011.08–2014.07
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248265 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 69260 1.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 74231 2.REMOVE FRONT ARMREST BASE PANEL UPPER (w/ Power Window)

Hide 74231 3.REMOVE FRONT ARMREST BASE PANEL UPPER (w/o Power Window)

Hide 67601 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 5 Door)

Hide 67601 5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 3 Door)

Hide 86160 6.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E222073

Disconnect the connector.


b.
E222074

Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the front No. 1 speaker assembly from the front door panel.


c.

Operate the drill around the rivet head circumference and cut out the flange.

CAUTION:

Be careful. The cut rivet is very hot.


NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.



d.

After drilling out the flange, continue drilling to push out the shards on the drill.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.