Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
69260
3.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
Insert a clip remover between the plate and front door trim board.
Turn the handle with the clip remover inserted, as shown in the illustration.
Remove the front door window regulator handle and clip.
Remove the window regulator handle plate.
74231
4.REMOVE FRONT ARMREST BASE UPPER PANEL (w/ Power Window)
Using a moulding remover, disengage the 9 claws and 4 guides.
Disconnect the connector and remove the front armrest base upper panel.
74231
5.REMOVE FRONT ARMREST BASE UPPER PANEL (w/o Power Window)
Using a moulding remover, disengage the 6 claws and 3 guides.
Disconnect the connector.
If the armrest base upper panel is equipped with door lock switch, disconnect the connector.
67601
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 5 Door)
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
| *1 | Protective Tape |
Remove the 3 screws.
Disengage the 7 clips.
Disconnect the front door lock remote control cable and the front door inside locking cable and remove the front door trim board.
| *1 | Front Door Lock Remote Control Cable Assembly |
| *2 | Front Door Inside Locking Cable Assembly |
67601
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 3 Door)
Using a screwdriver with its tip wrapped in protective tape, disengage the claw and open the cover.
| *1 | Protective Tape |
Remove the 3 screws.
Disengage the 8 clips.
Disconnect the front door lock remote control cable and the front door inside locking cable and remove the front door trim board.
| *1 | Front Door Lock Remote Control Cable Assembly |
| *2 | Front Door Inside Locking Cable Assembly |
69205
8.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY
Disengage the 4 guides and remove the front door inside handle.
68171B
9.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP (for 5 Door)
Disengage the 7 claws and remove the front door glass inner weatherstrip as shown in the illustration.
68171B
10.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP (for 3 Door)
Disengage the 8 claws and remove the front door glass inner weatherstrip as shown in the illustration.
75751C
11.REMOVE FRONT DOOR WINDOW FRAME FRONT MOULDING
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT DOOR WINDOW FRAME MOULDING(for Front Side)>REMOVAL).
75754A
12.REMOVE FRONT DOOR WINDOW FRAME UPPER MOULDING (for Driver Side)
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT DOOR WINDOW FRAME MOULDING(for Center)>REMOVAL).
87910
13.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY
Use the same procedure as for the LH side (See page Vehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL).
75755C
14.REMOVE FRONT DOOR WINDOW FRAME REAR MOULDING (for 3 Door)
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT DOOR WINDOW FRAME MOULDING(for Rear Side)>REMOVAL).
68160C
15.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT DOOR BELT MOULDING>REMOVAL).
89865
16.REMOVE DOOR SIDE AIRBAG SENSOR (for 3 Door)
w/ Curtain Shield Airbag:
Remove the door side airbag sensor (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SIDE AIRBAG SENSOR(for 3 Door)>REMOVAL).
86160
17.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY
67831
18.REMOVE FRONT DOOR SERVICE HOLE COVER (for 5 Door)
Remove the front door service hole cover.
Remove any tape remaining on the door side.
67831
19.REMOVE FRONT DOOR SERVICE HOLE COVER (for 3 Door)
Remove the front door service hole cover.
Remove any tape remaining on the door side.
68101
20.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
Remove the front door service hole cover.
Connect the cable to the negative (-) battery terminal.
Connect the power window regulator master switch and move the front door glass so that the door glass bolts can be seen.
Disconnect the cable from the negative (-) battery terminal and the power window regulator master switch.
Remove the 2 bolts.
Remove the front door glass as indicated by the arrows in the order shown in the illustration.
After the bolts are removed, do not allow the front door glass to fall.
69911A
21.REMOVE FRONT DOOR GLASS NO. 1 CHANNEL
Using a screwdriver with its tip wrapped in protective tape, remove the front door glass channel.
| *1 | Protective Tape |
Do not damage the front door glass.
69975E
22.REMOVE FRONT DOOR GLASS NO. 1 CHANNEL FILLER
Remove the front door glass No. 1 channel filler.
69801
23.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/ Power Window)
Disconnect the connector.
Loosen the temporary bolt.
| *1 | Temporary Bolt |
Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and cause damage.
Remove the 5 bolts.
Remove the temporary bolt and the front door window regulator.
69801
24.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY (w/o Power Window)
Loosen the temporary bolt.
| *1 | Temporary Bolt |
Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator may fall and cause damage.
Remove the 4 bolts.
Remove the temporary bolt and the front door window regulator.
68141C
25.REMOVE FRONT DOOR GLASS RUN
Remove the front door glass run.
67403F
26.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
Remove the bolt.
Disengage the guide and remove the front door rear lower frame.
67401F
27.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY
Remove the screw.
Remove the 2 bolts and the front door front lower frame.
68215
28.REMOVE FRONT DOOR FIX WINDOW WEATHERSTRIP
Slide the front door fix window weatherstrip, in the direction indicated by the arrow in the illustration, to remove it.
Remove the front door fix window glass from the front door fix window weatherstrip.
69217F
29.REMOVE FRONT DOOR OUTSIDE HANDLE COVER
Remove the hole plug.
Using a "TORX" socket wrench T30, loosen the screw and remove the front door outside handle cover with the door lock key cylinder installed.
The screw cannot be removed because it is integrated into the front door outside handle frame.
Disengage the 2 claws and remove the front door outside handle cover.
69030A
30.REMOVE FRONT DOOR LOCK ASSEMBLY (w/ Power Door Lock)
69030A
31.REMOVE FRONT DOOR LOCK ASSEMBLY (w/o Power Door Lock)
69210
32.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY
Remove the front door outside handle in the direction indicated by the arrow as shown in the illustration.
69241H
33.REMOVE FRONT DOOR OUTSIDE HANDLE FRONT PAD
Disengage the 3 claws and remove the front door outside handle front pad.
69242E
34.REMOVE FRONT DOOR OUTSIDE HANDLE REAR PAD
Disengage the 2 claws and remove the front door outside handle rear pad.
69201A
35.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
Using a "TORX" socket wrench T30, loosen the screw.
Slide the front door outside handle frame and disengage the grommet and 2 claws of the front door outside handle frame, and then remove it.
| *1 | Grommet |
69311A
36.REMOVE FRONT DOOR LOCK OPEN ROD
Remove the front door lock open rod as indicated by the arrows in the order shown in the illustration.
| *1 | Snap |
68610B
37.REMOVE FRONT DOOR CHECK ASSEMBLY
Remove the 3 bolts and the front door check.
67861
38.REMOVE FRONT DOOR WEATHERSTRIP (for 5 Door)
Using a clip remover, disengage the clip.
Using a clip remover, disengage the 29 clips and remove the front door weatherstrip.
67861
39.REMOVE FRONT DOOR WEATHERSTRIP (for 3 Door)
Using a clip remover, disengage the clip.
Using a clip remover, disengage the 32 clips and remove the front door weatherstrip.
67001A
40.REMOVE FRONT DOOR PANEL CUSHION
Remove the 2 front door panel cushions.
75921C
41.REMOVE NO. 1 BLACK OUT TAPE (for 5 Door)