Home › Audio / Visual / Telematics › AUDIO / VIDEO › FRONT DOOR SPEAKER › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248265 FRONT DOOR SPEAKER A

AUDIO / VIDEO  FRONT DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 74231 1.REMOVE FRONT ARMREST BASE UPPER PANEL

Hide 67601 2.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160 3.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

a.
E222073

Disconnect the connector.


b.
E293445

Using a drill bit with a diameter of less than 4 mm (0.16 in.), remove the 3 rivet heads as shown in the illustration.

CAUTION:

Be careful. The cut rivet is very hot.


NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.



c.

Continue drilling and push out the remaining rivet fragments.


d.

Disengage the claw and guide to remove the front No. 1 speaker assembly.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.