Home › Vehicle Exterior › DOOR / HATCH › FRONT DOOR › 2014.07–2016.09
RM19S0E _59 Vehicle Exterior _051502 DOOR / HATCH _0248392 FRONT DOOR A

DOOR / HATCH  FRONT DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 74231 3.REMOVE FRONT ARMREST BASE UPPER PANEL

a.
B377915

Using a moulding remover, disengage the 9 claws and 4 guides.


b.

Disconnect the connector to remove the front armrest base upper panel.


Hide 67601 4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

a.
B377916E02
2.104,1.375 2.771,0.896 false 2.823,0.729 3.021,0.917 0.198,0.188 10 true *a

Using a screwdriver with its tip wrapped in protective tape, disengage the claw to open the cover.

Text in Illustration
*a Protective Tape


b.
B377918

Remove the 3 screws.


c.
B369625

Disengage the 7 clips.


d.
B373462E02
1.25,0.938 1.073,0.469 false 1.177,1.458 1.302,1.292 false 0.844,0.313 1.031,0.51 0.188,0.198 10 true *1 0.958,1.479 1.135,1.698 0.177,0.219 10 true *2

Disconnect the front door lock remote control cable assembly and front door inside locking cable assembly to remove the front door trim board sub-assembly.

Text in Illustration
*1 Front Door Lock Remote Control Cable Assembly
*2 Front Door Inside Locking Cable Assembly


Hide 69205 5.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

a.
B373463

Disengage the 4 guides to remove the front door inside handle sub-assembly.


Hide 68171B 6.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

a.
B369626

Disengage the 7 claws to remove the front door glass inner weatherstrip as shown in the illustration.


Hide 75751C 7.REMOVE FRONT DOOR WINDOW FRAME FRONT MOULDING

Hide 87910 8.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>MIRROR (EXT)>OUTER REAR VIEW MIRROR>REMOVAL).


Hide 68160C 9.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

HINT:

Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>FRONT DOOR BELT MOULDING>REMOVAL).


Hide 86160 10.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 67831 11.REMOVE FRONT DOOR SERVICE HOLE COVER

a.
B271600

Remove the front door service hole cover.

HINT:

Remove any tape remaining on the door side.



Hide 68101 12.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

a.
B271601

Remove the front door service hole cover.


b.

Connect the cable to the negative (-) battery terminal.


c.

Connect the power window regulator master switch and move the front door glass so that the door glass bolts can be seen.


d.

Disconnect the cable from the negative (-) battery terminal and the power window regulator master switch.


e.
B271602

Remove the 2 bolts.


f.
B372730E01
1.746,0.121 1.902,0.297 0.156,0.177 10 1 0.963,0.555 1.119,0.731 0.156,0.177 10 2

Remove the front door glass sub-assembly as indicated by the arrows in the order shown in the illustration.

NOTICE:

After the bolts are removed, do not allow the front door glass sub-assembly to fall.



Hide 69801 13.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

a.
B312389E01
1.491,0.06 1.685,0.226 0.194,0.166 10 *a 1.534,0.271 1.427,0.782 false

Disconnect the connector.


b.

Loosen the temporary bolt.

Text in Illustration
*a Temporary Bolt

NOTICE:

Do not remove the temporary bolt. If the temporary bolt is removed, the front door window regulator sub-assembly may fall and cause damage.



c.

Remove the 5 bolts and front door window regulator sub-assembly.


d.

Remove the temporary bolt from the front door window regulator sub-assembly.


Hide 68141C 14.REMOVE FRONT DOOR GLASS RUN

a.
B271607

Remove the front door glass run.


Hide 67403F 15.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

a.
B271608

Remove the bolt.


b.

Disengage the guide to remove the front door rear lower frame sub-assembly.


Hide 67401F 16.REMOVE FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY

a.
B271609

Remove the screw.

HINT:

Peel back the front door weatherstrip to remove the screw.



b.

Remove the 2 bolts and front door front lower frame sub-assembly.


Hide 68125 17.REMOVE FRONT DOOR FIX WINDOW GLASS

a.
B359188

Remove the front door fix window glass with front door fix window weatherstrip as shown in the illustration.


Hide 68215 18.REMOVE FRONT DOOR FIX WINDOW WEATHERSTRIP

a.
B377919

Remove the front door fix window weatherstrip from the front door fix window glass.


Hide 69217E 19.REMOVE FRONT DOOR OUTSIDE HANDLE COVER

a.
B271615E04
0.531,1.521 0.531,1.24 false 0.448,1.552 0.76,1.75 0.313,0.198 10 false *1

Remove the hole plug.

Text in Illustration
*1 Hole Plug


b.

Using a T30 "TORX" socket wrench, loosen the screw to remove the front door outside handle cover with lock cylinder.

HINT:

The screw cannot be removed because it is integrated into the front door outside handle frame sub-assembly.



c.
B271703

Disengage the 2 guides and claw to remove the front door outside handle cover.


Hide 69030A 20.REMOVE FRONT DOOR LOCK ASSEMBLY

Hide 69210 21.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY

a.
B271617

Remove the front door outside handle assembly as shown in the illustration.


Hide 69241H 22.REMOVE FRONT DOOR OUTSIDE HANDLE FRONT PAD

a.
B271619

Disengage the 3 claws to remove the front door outside handle front pad.


Hide 69242E 23.REMOVE FRONT DOOR OUTSIDE HANDLE REAR PAD

a.
B271620

Disengage the 2 claws to remove the front door outside handle rear pad.


Hide 69201A 24.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY

a.
B271625

Using a T30 "TORX" socket wrench, loosen the screw.


b.
B373458

Disengage the grommet and 2 claws to remove the front door outside handle frame sub-assembly as shown in the illustration.


Hide 69311A 25.REMOVE FRONT DOOR LOCK OPEN ROD

a.
B372731E02
2.188,0.74 2.542,0.354 false 0.396,2.427 0.552,2.625 0.156,0.198 10 true 1 1.177,2.302 1.313,2.469 0.135,0.167 10 false 2 2.573,0.198 2.74,0.365 0.167,0.167 10 false *a

Disengage the snap to remove the front door lock open rod as indicated by the arrows in the order shown in the illustration.

Text in Illustration
*a Snap


Hide 68610B 26.REMOVE FRONT DOOR CHECK ASSEMBLY

a.
B271610

Remove the 3 bolts and front door check assembly.


Hide 67861 27.REMOVE FRONT DOOR WEATHERSTRIP

a.
B271613

Using a clip remover, remove the clip.


b.

Using a clip remover, disengage the 29 clips to remove the front door weatherstrip.


Hide 67001A 28.REMOVE FRONT DOOR PANEL CUSHION

a.
B271614

Remove the 2 front door panel cushions.


Hide 75921C 29.REMOVE NO. 1 BLACK OUT TAPE

HINT:

Use the same procedure as for the LH side (See pageVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>REMOVAL)