Home › Audio / Visual / Telematics › AUDIO / VIDEO › REAR DOOR SPEAKER › 2011.08–2014.07
RM19S0E _56 Audio / Visual / Telematics _051483 AUDIO / VIDEO _0248266 REAR DOOR SPEAKER A

AUDIO / VIDEO  REAR DOOR SPEAKER  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 67673A 1.REMOVE REAR DOOR FRAME GARNISH

Hide 69260E 2.REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 74271A 3.REMOVE REAR DOOR ARMREST BASE PANEL UPPER (w/ Power Window)

Hide 74271A 4.REMOVE REAR DOOR ARMREST BASE PANEL UPPER (w/o Power Window)

Hide 67603 5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 86160B 6.REMOVE REAR SPEAKER ASSEMBLY

a.
E222077

Disconnect the connector.


b.
E222078

Drill out the 3 rivet heads using a drill with a bit diameter of less than 4 mm (0.16 in.), and remove the rear speaker assembly from the rear door panel.


c.

Operate the drill around the rivet head circumference and cut out the flange.

CAUTION:

Be careful. The cut rivet is very hot.


NOTICE:

Do not drill the rivet at an angle as this will cause damage to the drill and drill hole. Line up the drill and rivet, and carefully drill the rivet head straight out.



d.

After drilling out the flange, continue drilling to push out the shards on the drill.


e.

Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.