Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051484 NAVIGATION / MULTI INFO DISPLAY _0248277 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B1579  Voice Recognition Microphone Disconnected  


DESCRIPTION

The navigation receiver assembly and amplifier microphone assembly are connected to each other using the microphone connection detection signal lines.

This DTC is stored when the microphone connection detection signal is disconnected.

DTC Code DTC Detection Condition Trouble Area
B1579 Telephone microphone signal is lost.
·

Amplifier microphone assembly

·

Navigation receiver assembly

·

Harness or connector



WIRING DIAGRAM

E346470E01
1.729,0.688 2.344,0.885 0.615,0.198 10 false MIO- 1.677,1.479 2.292,1.677 0.615,0.198 10 false SNS2 5.104,1.49 5.719,1.688 0.615,0.198 10 false SNS2 5.135,0.698 5.75,0.896 0.615,0.198 10 false MIN- 2.188,0.573 2.344,0.771 0.156,0.198 10 false 3 2.188,1.365 2.344,1.563 0.156,0.198 10 false 4 4.833,0.583 5.146,0.781 0.313,0.198 10 false 19 4.896,1.375 5.156,1.573 0.26,0.198 10 false 6 1,2.021 1.458,2.219 0.458,0.198 10 false F95 1,2.208 2.344,2.635 1.344,0.427 10 false Amplifier Microphone Assembly 4.99,2.031 5.604,2.229 0.615,0.198 10 false F132 4.99,2.198 6.26,2.792 1.271,0.594 10 false Navigation Receiver Assembly

PROCEDURE

1.CHECK NAVIGATION RECEIVER ASSEMBLY
a.
U158706E02
2.063,1.229 2.208,1.698 true 0.063,0.031 0.219,0.198 0.156,0.167 10 false *a 0.177,0.385 0.542,0.531 0.365,0.146 10 false F132 2.083,1.708 2.427,1.844 0.344,0.135 10 false MIN-

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F132-19 (MIN-) - Body ground Always Below 1 Ω


Text in Illustration
*a Component with harness connected
(Navigation Receiver Assembly)



OK

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - AMPLIFIER MICROPHONE ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - AMPLIFIER MICROPHONE ASSEMBLY)
a.

Disconnect the F132 navigation receiver assembly connector.


b.

Disconnect the F95 amplifier microphone assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
F132-6 (SNS2) - F95-4 (SNS2) Always Below 1 Ω
F132-19 (MIN-) - F95-3 (MIC-) Always Below 1 Ω
F132-6 (SNS2) - Body ground Always 10 kΩ or higher
F132-19 (MIN-) - Body ground Always 10 kΩ or higher




OK

3.INSPECT AMPLIFIER MICROPHONE ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT AMPLIFIER MICROPHONE ASSEMBLY
a.
E228890E15
0.157,0.082 0.348,0.273 0.191,0.191 10 *a 1.725,1.762 2.138,1.930 0.412,0.167 10 MCO- 1.057,1.762 1.469,1.930 0.412,0.167 10 SNS2 1.519,1.254 1.302,1.762 false 1.657,1.254 1.917,1.762 false

Remove the amplifier microphone assembly (See page Audio / Visual / Telematics>AUDIO / VIDEO>MICROPHONE AMPLIFIER>REMOVAL).


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
4 (SNS2) - 3 (MCO-) Always Below 1 Ω


Text in Illustration
*a Component with harness connected
(Amplifier Microphone Assembly)



OK

NG

REPLACE AMPLIFIER MICROPHONE ASSEMBLY