Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051484 NAVIGATION / MULTI INFO DISPLAY _0248277 NAVIGATION SYSTEM C

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM  B158D  Video Signal Stoppage  B15A0  LAN Master Malfunction  B15AD  Navigation Processor Malfunction  B15B0  Display Screen Malfunction  B15B3  Radio Tuner Malfunction  B15B4  CD Changer Malfunction  B15B7  Bluetooth Module Malfunction  


DESCRIPTION

These DTCs are stored when a malfunction occurs in the navigation receiver assembly.

DTC Code DTC Detection Condition Trouble Area
B158D The internal video signal of the navigation receiver assembly is interrupted Navigation receiver assembly
B15A0 When either of the conditions below is met:
·

Bus malfunction

·

EEPROM error


B15AD When any of the following conditions is met:
·

Short to ground or +B or open occurs in gyro signal circuit

·

Gyro sensor malfunction

·

GPS receiver malfunction


B15B0 Picture circuit (TFT unit) malfunction
B15B3 When one of the conditions below is met:
·

AM tuner PLL is unlocked

·

FM tuner PLL is unlocked

·

Tuner malfunction


B15B4 When one of the conditions below is met:
·

Mechanical communication error

·

Load/Eject malfunction

·

Read malfunction

·

Mechanical malfunction


B15B7 "Bluetooth" module malfunction

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections (See page General>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING).