Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM › from 2014.07
RM19S0E _56 Audio / Visual / Telematics _051485 PARK ASSIST / MONITORING _0248279 REAR VIEW MONITOR SYSTEM U

PARK ASSIST / MONITORING  REAR VIEW MONITOR SYSTEM  TERMINALS OF ECU  


REAR TELEVISION CAMERA ASSEMBLY


U158709E02
3.458,0.281 3.719,0.458 0.26,0.177 10 false P15

a.

Disconnect the P15 rear television camera assembly connector.


b.

Measure the voltage and resistance according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
P15-5 (CGND) - Body ground BR - Body ground Ground Always Below 1 Ω
P15-6 (CB+) - Body ground R - Body ground Power source Ignition switch ON, shift lever in R 5.5 to 7.1 V

If the result is not as specified, there may be a malfunction on the wire harness side.


c.

Reconnect the rear television camera assembly connector.


d.

Measure the waveform according to the value(s) in the table below.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
P15-3 (CV+) - P15-2 (CV-) B - W Video signal Ignition switch ON, shift lever in R Pulse generation
(See waveform 1)
Ignition switch ON, shift lever in R, screen blacked out by covering camera lens Pulse generation
(See waveform 2)

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly*1 or navigation receiver assembly*2 with the connector connected.


If the result is not as specified, the rear television camera assembly may have a malfunction.

*1: w/o Navigation System

*2: w/ Navigation System



e.

Using an oscilloscope, check the waveform.

E346374E01
1.26,2.323 1.417,1.917 false 1.719,2.323 1.531,1.813 false 4.698,2.323 4.844,1.75 false 5.177,2.313 4.958,1.677 false 0.573,0.365 0.885,0.563 0.313,0.198 10 false *a 0.656,1.354 1.115,1.552 0.458,0.198 10 false GND 1.167,2.354 1.479,2.552 0.313,0.198 10 false *c 1.708,2.354 2.021,2.552 0.313,0.198 10 false *d 4.042,1.344 4.5,1.542 0.458,0.198 10 false GND 4.604,2.354 4.917,2.552 0.313,0.198 10 false *c 5.115,2.354 5.427,2.552 0.313,0.198 10 false *d 3.917,0.375 4.229,0.573 0.313,0.198 10 false *b

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the inner rear view assembly with the connector connected.


i.

Waveform 1 (Reference)

Item Content
Terminal No. (Symbol) P15-3 (CV+) - P15-2 (CV-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.



ii.

Waveform 2 (Reference)

Item Content
Terminal No. (Symbol) P15-3 (CV+) - P15-2 (CV-)
Tool Setting 200 mV/DIV., 50 μsec./DIV.
Condition Ignition switch ON, shift lever in R, screen blacked out by covering camera lens

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.


Text in Illustration
*a Waveform 1
*b Waveform 2
*c Synchronized Signal
*d Video Waveform





NAVIGATION RECEIVER ASSEMBLY (w/ Navigation System)


(See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM>TERMINALS OF ECU)