| Detection Item | Symptom | Trouble Area |
|---|---|---|
| ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode | Either condition is met:
·
"Skid Control (ABS/VSC/TRAC)" is not displayed on "Bus Check". ·
"ABS and Traction Actuator (Skid Control ECU) Communication Stop Mode" in "DTC Combination Table" applies. |
·
Power source or inside skid control ECU (brake actuator assembly) ·
Skid control ECU (brake actuator assembly) branch wire or connector ·
Skid control ECU (brake actuator assembly) |
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Turn the ignition switch off before measuring the resistances between CAN bus main wires and between CAN bus branch wires.
Turn the ignition switch off before inspecting CAN bus wires for a ground short.
After the ignition switch is turned off, check that the key reminder warning system are not operating.
Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If any doors need to be opened in order to check connectors, open the doors and leave them open.
Operating the ignition switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
Disconnect the A54 skid control ECU (brake actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A54-25 (CANH) - A54-14 (CANL) | Ignition switch off | 54 to 69 Ω |
| *a | Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly)) |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A54-12 (+BS) - Body ground | Always | 11 to 14 V |
| A54-24 (BM) - Body ground | Always | 11 to 14 V |
| A54-34 (IG1) - Body ground | Ignition switch ON | 11 to 14 V |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A54-1 (GND1) - Body ground | Always | Below 1 Ω |
| A54-13 (GND2) - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to Skid Control ECU (Brake Actuator Assembly)) |
OK
NG