Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
69260
1.REMOVE FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
74231
2.REMOVE FRONT ARMREST BASE UPPER PANEL (w/ Power Window)
74231
3.REMOVE FRONT ARMREST BASE UPPER PANEL (w/o Power Window)
67601
4.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 5 Door)
67601
5.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY (for 3 Door)
67831
6.REMOVE FRONT DOOR SERVICE HOLE COVER (for 5 Door)
67831
7.REMOVE FRONT DOOR SERVICE HOLE COVER (for 3 Door)
68101
8.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68141C
9.REMOVE FRONT DOOR GLASS RUN
67403F
10.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
69217E
11.REMOVE FRONT DOOR OUTSIDE HANDLE COVER
Remove the hole plug.
Using a "TORX" socket wrench T30, remove the screw and the front door lock cylinder assembly.
69030A
12.REMOVE FRONT DOOR LOCK ASSEMBLY (w/ Power Door Lock)
Disconnect the connector.
Using a "TORX" socket wrench T30, remove the 3 screws.
Slide the front door lock assembly downward, and remove the front door lock from the front door lock open rod.
| *1 | Front Door Lock Open Rod |
|
Slide Direction |
Remove the door lock wire harness seal from the front door lock.
69030A
13.REMOVE FRONT DOOR LOCK ASSEMBLY (w/o Power Door Lock)
Using a "TORX" socket wrench T30, remove the 3 screws.
Slide the front door lock assembly downward, and remove the front door lock from the front door lock open rod.
| *1 | Front Door Lock Open Rod |
|
Slide Direction |
Remove the door lock wire harness seal from the front door lock.
69710B
14.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the 7 claws.
| *1 | Protective Tape |
Remove the front door lock remote control cable assembly from the front door lock.
69750C
15.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
Remove the front door inside locking cable assembly from the front door lock.