Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
74231
1.REMOVE FRONT ARMREST BASE UPPER PANEL
67601
2.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
67831
3.REMOVE FRONT DOOR SERVICE HOLE COVER
68101
4.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68141C
5.REMOVE FRONT DOOR GLASS RUN
67403F
6.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
69217E
7.REMOVE FRONT DOOR OUTSIDE HANDLE COVER
Remove the hole plug.
| *1 | Hole Plug |
Using a T30 "TORX" socket wrench, loosen the screw to remove the front door outside handle cover with lock cylinder.
69030A
8.REMOVE FRONT DOOR LOCK ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Remove the front door lock assembly from the front door lock open rod as shown in the illustration.
| *1 | Front Door Lock Open Rod |
Remove the door lock wire harness seal from the front door lock assembly.
69710B
9.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the 5 claws to open the cover.
| *a | Protective Tape |
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
69750C
10.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
Disengage the guide to remove the front door inside locking cable assembly from the front door lock assembly.