69770B
1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
Engage the guide to install the rear door inside locking cable assembly to the rear door lock assembly.
Engage the 3 claws to close the cover.
69730D
2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Engage the guide to install the rear door lock remote control cable assembly to the rear door lock assembly.
Engage the 2 claws to close the cover.
69050A
3.INSTALL REAR DOOR LOCK ASSEMBLY
If reusing the rear door lock assembly that has been removed, replace the door lock wire harness seal with a new seal.
Make sure that no grease or dirt adheres to the door lock wire harness seal surface.
Reusing the door lock wire harness seal or using a damaged door lock wire harness seal may cause water intrusion to the connection. This may result in a malfunction of the rear door lock assembly.
Apply MP grease to the sliding parts of the rear door lock assembly.
Install a new door lock wire harness seal to the rear door lock assembly.
Install the rear door lock assembly to the release plate.
| *1 | Release Plate |
Make sure that the release plate is securely connected to the rear door lock assembly.
Using a T30 "TORX" socket wrench, install the rear door lock assembly with the 3 screws.
Connect the connector.
68142C
4.INSTALL REAR DOOR GLASS RUN
68103
5.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
67407E
6.INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
67841E
7.INSTALL REAR DOOR SERVICE HOLE COVER
67603
8.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74271A
9.INSTALL REAR DOOR ARMREST BASE UPPER PANEL
67673A
10.INSTALL REAR DOOR FRAME GARNISH