Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
67673A
1.REMOVE REAR DOOR FRAME GARNISH
74271A
2.REMOVE REAR DOOR ARMREST BASE UPPER PANEL
67603
3.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
67841E
4.REMOVE REAR DOOR SERVICE HOLE COVER
67407E
5.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
68103
6.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
68142C
7.REMOVE REAR DOOR GLASS RUN
69050A
8.REMOVE REAR DOOR LOCK ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Remove the rear door lock assembly from the release plate as shown in the illustration.
| *1 | Release Plate |
Remove the door lock wire harness seal from the rear door lock assembly.
69730D
9.REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to open the cover.
| *a | Protective Tape |
Disengage the guide to remove the rear door lock remote control cable assembly from rear door lock assembly.
69770B
10.REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws to open the cover.
| *a | Protective Tape |
Disengage the guide to remove the rear door inside locking cable assembly from the rear door lock assembly.