Use the same procedure for both the RH and LH sides.
The procedure described below is for the RH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
67673A
3.REMOVE REAR DOOR FRAME GARNISH
Disengage the 2 clips and claw.
Disengage the guide to remove the rear door frame garnish.
74271A
4.REMOVE REAR DOOR ARMREST BASE UPPER PANEL
Using a moulding remover, disengage the 8 claws and 3 guides.
Disconnect the connector to remove the rear door armrest base upper panel.
67603
5.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, disengage the claw to open the cover.
| *a | Protective Tape |
Remove the 3 screws.
Disengage the 7 clips.
Disconnect the rear door lock remote control cable assembly and rear door inside locking cable assembly to remove the rear door trim board sub-assembly.
| *1 | Rear Door Lock Remote Control Cable Assembly |
| *2 | Rear Door Inside Locking Cable Assembly |
69205A
6.REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY
Disengage the 4 guides to remove the rear door inside handle sub-assembly.
68173B
7.REMOVE REAR DOOR GLASS INNER WEATHERSTRIP
Disengage the 7 claws to remove the rear door glass inner weatherstrip as shown in the illustration.
86160B
8.REMOVE REAR SPEAKER ASSEMBLY
67841E
9.REMOVE REAR DOOR SERVICE HOLE COVER
Remove the rear door service hole cover.
Remove any tape remaining on the door side.
67407E
10.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY
Remove the 3 bolts.
Remove the nut and rear door window division bar sub-assembly.
68103
11.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
Slide the lower section of the rear door glass as indicated by the arrow as shown in the illustration.
Remove the rear door glass sub-assembly as indicated by the arrows in the order shown in the illustration.
Do not damage the rear door glass sub-assembly.
69905B
12.REMOVE REAR DOOR GLASS CHANNEL SUB-ASSEMBLY
Using a screwdriver with its tip wrapped in protective tape, remove the rear door glass channel sub-assembly.
| *a | Protective Tape |
Do not damage the rear door glass sub-assembly.
69975A
13.REMOVE REAR DOOR GLASS CHANNEL FILLER
Remove the rear door glass channel filler.
69803
14.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY
Disconnect the connector.
| *a | Temporary Bolt |
Loosen the temporary bolt.
Do not remove the temporary bolt. If the temporary bolt is removed, the rear door window regulator sub-assembly may fall and cause damage.
Remove the 3 bolts and rear door window regulator sub-assembly.
Remove the temporary bolt from the rear door window regulator sub-assembly.
68142C
15.REMOVE REAR DOOR GLASS RUN
Remove the clip.
Disengage the 2 guides to remove the rear door glass run.
68180C
16.REMOVE REAR DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>REAR DOOR BELT MOULDING>REMOVAL).
69050A
17.REMOVE REAR DOOR LOCK ASSEMBLY
69227J
18.REMOVE REAR DOOR OUTSIDE HANDLE COVER
Using a T30 "TORX" socket wrench, loosen the screw.
Disengage the 2 claws to remove the rear door outside handle cover.
69230
19.REMOVE REAR DOOR OUTSIDE HANDLE ASSEMBLY
Remove the rear door outside handle assembly as shown in the illustration.
69241G
20.REMOVE REAR DOOR OUTSIDE HANDLE FRONT PAD
Disengage the 3 claws to remove the rear door outside handle front pad.
69242G
21.REMOVE REAR DOOR OUTSIDE HANDLE REAR PAD
Disengage the 2 claws to remove the rear door outside handle rear pad.
69203A
22.REMOVE REAR DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY
Using a T30 "TORX" socket wrench, loosen the screw.
Disengage the grommet and 2 claws to remove the rear door outside handle frame sub-assembly as shown in the illustration.
68630D
23.REMOVE REAR DOOR CHECK ASSEMBLY
Remove the 3 bolts and rear door check assembly.
67871
24.REMOVE REAR DOOR WEATHERSTRIP
Using a clip remover, remove the 2 clips.
Using a clip remover, disengage the 29 clips to remove the rear door weatherstrip.
75923
25.REMOVE NO. 2 BLACK OUT TAPE
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Rear Door)>REMOVAL).