When the engine immobiliser system is set, the theft warning indicator light assembly blinks continuously, but does not illuminate if the engine immobiliser system is not set.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
When replacing the transponder key ECU assembly, refer to the Service Bulletin.
Check for DTCs (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Immobiliser / Active Test.
According to the display on the intelligent tester, perform the Active Test.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Security Indicator | Theft warning indicator light assembly | OFF / ON | - |
Theft warning indicator light assembly can be turned on and off using the intelligent tester.
OK
NG
Turn the ignition switch off.
When using the intelligent tester with the ignition switch off to troubleshoot: Connect the intelligent tester to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 second until communication between the intelligent tester and vehicle begins.
Using the intelligent tester, read the Data List (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE IMMOBILISER SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Immobiliser | Engine immobiliser system status determined by transponder key ECU assembly / Set or Unset | Set: Engine immobiliser set (engine start prohibited [no key in ignition key cylinder])
Unset: Engine immobiliser unset (engine start permitted [key inserted in ignition key cylinder]) |
When the engine immobiliser system does not change to the unset state, this item can be used to determine if the cause is the transponder key ECU assembly. |
OK
NG
Disconnect the F54 transponder key ECU assembly connector.
Disconnect the F56 theft warning indicator light assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F54-8 (IND) - F56-2 (LP) | Always | Below 1 Ω |
| F56-6 (E) - Body ground | Always | Below 1 Ω |
| F54-8 (IND) - Body ground | Always | 10 kΩ or higher |
OK
NG
Inspect the theft warning indicator light assembly (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SECURITY INDICATOR LIGHT ASSEMBLY>INSPECTION).
OK
NG
(See pageVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>SECURITY INDICATOR LIGHT ASSEMBLY>REMOVAL)
Disconnect the F54 transponder key ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F54-16 (GND) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F54-1 (+B) - Body ground | Always | 11 to 14 V |
| F54-2 (IG) - Body ground | Ignition switch off | Below 1 V |
| Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to Transponder Key ECU Assembly) |
OK
NG