If a trouble code is output during the DTC check, inspect the trouble areas listed for that code. For details of the code, refer to the "See page" below.
Either condition is met:
- Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal*1 or clutch pedal*2 depressed, turn the ignition switch to ON). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds).
- 10 seconds after the ignition switch is turned to ON after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the ignition switch being turned to ON, and DTCs are stored after 6 seconds).
()
B279A
Theft Deterrent System Communication Line High Fixation
Turn the ignition switch to ON and wait 6 seconds.