Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM › 2014.07–2015.06
RM19S0E _58 Vehicle Interior _051493 METER / GAUGE / DISPLAY _0248310 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Malfunction in Water Temperature Warning Light  


DESCRIPTION

In this circuit, the meter CPU receives engine coolant temperature signals from the ECM using the CAN communication system (CAN V1 Bus). The meter CPU displays engine coolant temperature that is calculated based on the data received from the ECM.

WIRING DIAGRAM

E346310E03
0.563,3.146 1,3.344 0.438,0.198 10 false ECM 2.927,3.219 4.688,3.427 1.76,0.208 10 false : CAN Communication Line 5.292,3.156 7.156,3.354 1.865,0.198 10 false Combination Meter Assembly

CAUTION / NOTICE / HINT

HINT:

If there is an open or short in the engine coolant temperature sensor circuit, the ECM stores the DTCs. Troubleshoot the SFI System.



PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check if a CAN communication DTC is output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(except Separate Type Yaw Rate Sensor)>DIAGNOSIS SYSTEM).

Result
Result Proceed to
CAN communication DTC is not output A
CAN communication DTC is output B



A

2.PERFORM ACTIVE TEST USING GTS (COOLANT TEMP)

B

2.PERFORM ACTIVE TEST USING GTS (COOLANT TEMP)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body / Combination Meter / Active Test.


e.

According to the display on the GTS, perform the Active Test.

Combination Meter
Tester Display Test Part Control Range Diagnostic Note
Indicat. Lamp Coolant Cool Engine coolant temperature indicator light OFF/ON Vehicle is stopped and engine is idling
Indicat. Lamp Coolant Hot Engine coolant temperature warning light OFF/ON Vehicle is stopped and engine is idling

OK:

Value selected during Active Test is displayed.




OK

3.READ VALUE USING GTS (COOLANT TEMPERATURE)

NG

REPLACE COMBINATION METER ASSEMBLY

3.READ VALUE USING GTS (COOLANT TEMPERATURE)
a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Body / Combination Meter / Data List.


e.

According to the display on the GTS, read the Data List.

Combination Meter
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Coolant Temperature Engine coolant temperature/
Min.: 0 (32)
Max.: 127.5 (261.5)
After warming up:
80 to 100 (176 to 212)
Unit: °C (°F)

OK:

Vehicle's coolant temperature and tester value are the same.




OK

4.CHECK ENGINE CONTROL SYSTEM

NG

REPLACE COMBINATION METER ASSEMBLY

4.CHECK ENGINE CONTROL SYSTEM
a.

Check if an engine control DTC is output.


Result
Result Proceed to
Engine control DTC is not output A
Engine control DTC is output (for 2NZ-FE) B
Engine control DTC is output (for 1NZ-FE) C



A

REPLACE COMBINATION METER ASSEMBLY

B

C