Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY › 2011.08–2014.07
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248319 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 55302A 3.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 73960A 5.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

B282641

a.

Remove the 2 screws.


b.

Disengage the 2 clamps.


c.
B282642E02
1.146,0.385 1.292,0.563 0.146,0.177 10 true A 1.156,1.625 1.313,1.823 0.156,0.198 10 true B 1.635,0.385 1.781,0.563 0.146,0.177 10 true A 2.135,0.385 2.281,0.563 0.146,0.177 10 true A 1.656,1.615 1.813,1.813 0.156,0.198 10 true B 2.156,1.604 2.313,1.802 0.156,0.198 10 true B

Disengage the 3 hooks A.


d.

Disengage the 3 hooks B to remove the instrument panel passenger airbag assembly as shown in the illustration.


Hide 82142A 6.REMOVE NO. 2 INSTRUMENT PANEL WIRE

B282643E01
0.856,0.611 0.456,0.959 false 0.348,0.967 0.508,1.113 0.160,0.146 10 *1 1.424,0.527 1.133,0.718 false 1.429,0.44 1.589,0.586 0.160,0.146 10 *2

a.

Using a thin-bladed screwdriver with its tip wrapped with protective tape, release the locking button.


b.

Using a thin-bladed screwdriver with its tip wrapped with protective tape, disconnect the airbag connector and remove the No. 2 instrument panel wire.

Text in Illustration
*1 Protective Tape
*2 Locking Button