Home › Vehicle Interior › INTERIOR PANELS / TRIM › UPPER INSTRUMENT PANEL › 2011.08–2014.07
RM19S0E _58 Vehicle Interior _051500 INTERIOR PANELS / TRIM _0248374 UPPER INSTRUMENT PANEL A

INTERIOR PANELS / TRIM  UPPER INSTRUMENT PANEL  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

All bolts, screws and nuts relevant to installing and removing the instrument panel are shown, along with their alphabetic codes, in the table below.

B272540E01
0.484,0.702 0.843,0.862 0.359,0.160 10 Code 0.527,1.569 0.802,1.729 0.275,0.160 10 <A> 1.968,0.696 2.391,0.868 0.423,0.173 10 Shape 3.657,0.702 4.016,0.862 0.359,0.160 10 Code 5.199,0.696 5.632,0.868 0.433,0.173 10 Shape 3.694,1.569 3.979,1.729 0.285,0.160 10 <B> 5.5,0.137 6.730,0.330 1.230,0.193 10 mm(in.) (L=Length) 2.809,1.3 3.261,1.965 0.452,0.665 10 φ=5 (0.20) L=14 (0.55) 6.06,1.3 6.512,1.965 0.452,0.665 10 φ=8 (0.31) L=21 (0.83)


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE RH (for 5 Door)

Hide 67914 4.REMOVE FRONT DOOR SCUFF PLATE LH (for 5 Door)

HINT:

Use the same procedure as for the RH side.


Hide 67913 5.REMOVE FRONT DOOR SCUFF PLATE RH (for 3 Door)

Hide 67914 6.REMOVE FRONT DOOR SCUFF PLATE LH (for 3 Door)

HINT:

Use the same procedure as for the RH side.


Hide 62112 8.REMOVE COWL SIDE TRIM BOARD LH

HINT:

Use the same procedure as for the RH side.


Hide 62311B 9.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP RH

a.

Separate the front door opening trim weatherstrip.


Hide 62312B 10.SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.

Separate the front door opening trim weatherstrip.


Hide 62211 11.REMOVE FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag)

Hide 62212 12.REMOVE FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag)

HINT:

Use the same procedure as for the RH side.


Hide 62211 13.REMOVE FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag)

Hide 62212 14.REMOVE FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag)

HINT:

Use the same procedure as for the RH side.


Hide 55470 15.REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH ASSEMBLY

a.
B290391E01
0.284,0.495 0.399,0.640 0.115,0.145 10 A 0.429,0.62 0.626,0.721 false

Disengage the 10 clips and the 4 guides and remove the instrument cluster finish panel garnish.

HINT:

Disengage the clips in order starting from the outside of the vehicle.


NOTICE:

To prevent parts from breaking, do not pull on section A when disengaging the clips.



Hide 55680A 16.REMOVE NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY (for Front Passenger Side)

a.
B272542

Disengage the 3 claws and remove the instrument panel register.


Hide 55405B 17.REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/o Radio Receiver)

a.
B290375

Disengage the 7 clips.


b.

Disconnect the connector and remove the instrument cluster finish center panel.


Hide 55405B 18.REMOVE INSTRUMENT CLUSTER FINISH CENTER PANEL SUB-ASSEMBLY (w/ Radio Receiver)

a.
B290376

Disengage the 4 clips.


b.

Disconnect the connector and remove the instrument cluster finish center panel.


Hide 55411G 19.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL

a.
B284246

Disengage the 5 clips and remove the instrument cluster finish panel.


Hide 83100 20.REMOVE COMBINATION METER ASSEMBLY

Hide 55302A 21.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

a.
B284247E01
0.982,2.002 1.166,2.165 0.185,0.163 10 *1 1.008,2.158 0.742,2.46 false

Slide the slider and disconnect the passenger airbag connector.

Text in Illustration
*1 Slider


b.
B284248

Remove the <B> bolt.


c.

Remove the 2 clips.

B290377


d.

Disengage the 8 clips while lifting the rear instrument panel up.


e.

While lifting the instrument panel, slide it toward the rear of the vehicle. Disengage the 5 guides of the front side of the instrument panel and remove the upper instrument panel.

NOTICE:

Be careful not to damage the upper instrument panel and steering wheel when removing it.