Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR(for 3 Door)
RM19S0E _58 Vehicle Interior _051495 SUPPLEMENTAL RESTRAINT SYSTEMS _0248327 SIDE AIRBAG SENSOR(for 3 Door) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR(for 3 Door)  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 89865 1.INSTALL DOOR SIDE AIRBAG SENSOR

a.

Check that the ignition switch is off.


b.

Confirm that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.

Insert the pin (stopper) into the body hole and install the front airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

If the door side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

·

When installing the door side airbag sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

·

Make sure that the pin (stopper) is securely inserted into the body hole.

·

Tighten the bolt while holding the door side airbag sensor because the door side airbag sensor pin (stopper) is easily damaged.




d.

Connect the connector to the door side airbag sensor.

NOTICE:

When connecting any airbag connector, take care not to damage the airbag wire harness.


i.

Connect the connector as shown in the illustration (when locking, make sure that the outer connector locking sleeve returns to its original position and a click sound can be heard).

C198070E06
3.541,1.785 3.877,1.949 0.336,0.164 10 *a 3.868,2.097 4.054,2.245 0.186,0.148 10 *1 3.945,1.31 3.945,2.083 false 5.794,1.637 5.794,2.083 false 5.699,2.102 5.886,2.25 0.186,0.148 10 *1

Text in Illustration
*1 Outer Connector Locking Sleeve - -
*a Slide - -

HINT:

When connected, the outer connector locking sleeve will slide. Be sure not to hold the outer connector locking sleeve while connecting, as it may result in an insecure fit.




e.

Check that there is no looseness in the installation parts of the door side airbag sensor.


Hide 67601 2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74231 3.INSTALL FRONT ARMREST BASE UPPER PANEL (w/ Power Window)

Hide 74231 4.INSTALL FRONT ARMREST BASE UPPER PANEL (w/o Power Window)

Hide 69260 5.INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 8.INSPECT POWER WINDOW OPERATION