Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).
The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
3.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
4.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
5.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)
58410B
6.REMOVE DECK BOARD ASSEMBLY
64771G
7.REMOVE SPARE WHEEL COVER
81250
8.REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
09113
9.REMOVE JACK HANDLE (for RH Side)
58387B
10.REMOVE REAR FLOOR FINISH PLATE
67917A
11.REMOVE REAR DOOR SCUFF PLATE
62331A
12.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
73360
13.SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
64730B
14.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
64740C
15.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
89860B
16.REMOVE NO. 2 SIDE AIRBAG SENSOR ASSEMBLY
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
Disconnect the connector from the No. 2 side airbag sensor assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.
| *1 | Housing Lock | *2 | Outer Connector Locking Sleeve |
| *a | Slide | - | - |
Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.
Remove the bolt and No. 2 side airbag sensor assembly.
Loosen the bolt while holding the No. 2 side airbag sensor assembly because the No. 2 side airbag sensor assembly pin (stopper) is easily damaged.