Wear protective gloves. Sharp areas on the parts may injure your hands.
71077S
1.INSTALL SEPARATE TYPE REAR SEATBACK COVER
Using hog ring pliers, install the separate type rear seatback cover to the separate type rear seatback pad with 12 new hog rings.
| *1 | New Hog Ring |
| *2 | Hog Ring Pliers |
Do not soil or scratch the separate type rear seatback cover.
When installing hog rings, minimize wrinkles as much as possible.
72630C
2.INSTALL REAR SEATBACK LOCK ASSEMBLY RH
Install the rear seatback lock assembly RH with the 2 bolts.
72640A
3.INSTALL REAR SEATBACK LOCK ASSEMBLY LH
Use the same procedure as for the RH side.
71017A
4.INSTALL REAR SEATBACK FRAME SUB-ASSEMBLY
Temporarily install the rear seatback frame sub-assembly.
Fasten the 2 zippers and engage the 2 hooks.
Engage the hook to install the rear seatback frame sub-assembly.
71931A
5.INSTALL REAR SEAT HEADREST SUPPORT
Align the protruding portion of the rear seat headrest support with the installation groove of the rear seat frame sub-assembly. (w/ Rear Center Seat Headrest)
| *a | protruding |
Engage the 12 claws to install the 6 rear seat headrest supports.
Align the protruding portion of the rear seat headrest support with the installation groove of the rear seat frame sub-assembly. (w/o Rear Center Seat Headrest)
| *a | protruding |
Engage the 8 claws and install the 4 rear seat headrest supports.
72646
6.INSTALL REAR SEATBACK STOP BUTTON GROMMET
Use the same procedure for both sides.
Engage the 2 claws to install the rear seatback stop button grommet.
72661C
7.INSTALL REAR SEATBACK LOCK RELEASE BUTTON
Use the same procedure for both sides.
Turn the rear seatback lock release button in the direction indicated by arrow to install it.
72996A
8.INSTALL REAR SEATBACK COVER
Use the same procedure for the remaining parts. (w/ Center Top Tether anchor Bar)
Use the same procedure for both sides. (w/o Center Top Tether anchor Bar)
Engage the 4 claws to install the rear seatback cover.
71960B
9.INSTALL REAR SEAT CENTER HEADREST ASSEMBLY (w/ Rear Center Seat Headrest)
Install the rear seat center headrest assembly.
71940A
10.INSTALL REAR SEAT HEADREST ASSEMBLY
Install the 2 rear seat headrest assemblies.
71075B
11.INSTALL BENCH TYPE REAR SEAT CUSHION COVER