Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door)
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248339 FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door) A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION).


HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


Hide 3.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)

Hide 4.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)

Hide 5.REMOVE REAR SEAT ASSEMBLY (for Fold Down Seat Type)

Hide 62311B 7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 73201C 8.REMOVE FRONT SEAT BELT OUTER BAR SUB-ASSEMBLY

a.
B282674

Remove the 2 bolts and front seat belt outer bar sub-assembly, disconnect the floor anchor part of the front seat outer belt assembly.


Hide 62510P 9.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

Hide 73210 11.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B282671

Remove the bolt and the shoulder anchor part of the front seat outer belt assembly.


b.
B282672E01
0.722,1.68 1.001,1.556 false 1.009,1.472 1.169,1.635 0.160,0.162 10 *1 0.615,2.073 0.544,1.717 false 0.514,2.066 0.674,2.228 0.160,0.162 10 *2 0.629,1.682 0.7,1.646 false 0.647,1.699 0.728,1.653 false 0.674,1.709 0.755,1.663 false 0.686,1.721 0.768,1.676 false 0.713,1.725 0.795,1.68 false 0.732,1.738 0.813,1.693 false 0.753,1.741 0.834,1.695 false 0.785,1.744 0.866,1.698 false 0.824,1.752 0.897,1.714 false

Using a screwdriver with its tip wrapped in protective tape, release the locking button.


c.

Disconnect the pretensioner connector.

Text in Illustration
*1 Protective Tape
*2 Locking Button


d.
B282673

Remove the 2 bolts.


e.

Disengage the 2 hooks and remove the front seat outer belt assembly.