58410B
1.REMOVE DECK BOARD ASSEMBLY
64771G
2.REMOVE SPARE WHEEL COVER
3.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)
4.REMOVE REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
5.REMOVE REAR SEATBACK ASSEMBLY (for Fold Down Seat Type)
67913
6.REMOVE FRONT DOOR SCUFF PLATE RH
Disengage the 8 claws and remove the front door scuff plate.
67914
7.REMOVE FRONT DOOR SCUFF PLATE LH
Use the same procedure as for the RH side.
62111C
8.REMOVE COWL SIDE TRIM BOARD RH
62112
9.REMOVE COWL SIDE TRIM BOARD LH
Use the same procedure as for the RH side.
62311B
10.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP RH
Remove the front door opening trim weatherstrip.
62312B
11.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
Use the same procedure as for the RH side.
73201C
12.REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY RH
73202B
13.REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY LH
Use the same procedure as for the RH side.
62510P
14.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY RH
Disengage the 8 clips and 10 claws.
Disengage the 3 guides and remove the quarter trim panel.
62520P
15.REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY LH
Use the same procedure as for the RH side.
62411B
16.REMOVE CENTER PILLAR UPPER GARNISH RH
Remove the 2 screws and disengage the clip.
Pass the front seat outer belt through the slit in the center pillar upper garnish and remove the center pillar upper garnish.
62412B
17.REMOVE CENTER PILLAR UPPER GARNISH LH
Use the same procedure as for the RH side.
62211
18.REMOVE FRONT PILLAR GARNISH RH (w/ Curtain Shield Airbag)
62212
19.REMOVE FRONT PILLAR GARNISH LH (w/ Curtain Shield Airbag)
Use the same procedure as for the RH side.
62211
20.REMOVE FRONT PILLAR GARNISH RH (w/o Curtain Shield Airbag)
62212
21.REMOVE FRONT PILLAR GARNISH LH (w/o Curtain Shield Airbag)
Use the same procedure as for the RH side.
81250
22.REMOVE NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
09113
23.REMOVE JACK HANDLE
58387B
24.REMOVE REAR FLOOR FINISH PLATE
73360
25.SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY RH
Remove the bolt.
Disengage the 2 claws and separate the rear seat 3 point type outer belt.
73370
26.SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY LH
Use the same procedure as for the RH side.
64730B
27.REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH
Remove the 3 screws.
Disengage the 3 clips and the 3 claws and remove the deck trim side panel.
64740C
28.REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Use the same procedure as for the RH side.
62471A
29.REMOVE ROOF SIDE INNER GARNISH RH
Disengage the 5 clips.
Pass the rear seat 3 point type outer belt through the slit in the roof side inner garnish and remove the roof side inner garnish.
62472A
30.REMOVE ROOF SIDE INNER GARNISH LH
Use the same procedure as for the RH side.
62451C
31.REMOVE REAR ROOF SIDE RAIL GARNISH RH
Disengage the 4 clips and remove the roof side rail garnish.
62452C
32.REMOVE REAR ROOF SIDE RAIL GARNISH LH
Use the same procedure as for the RH side.
74310
33.REMOVE VISOR ASSEMBLY RH
74320
34.REMOVE VISOR ASSEMBLY LH
Use the same procedure as for the RH side.
74348
35.REMOVE VISOR HOLDER
74610S
36.REMOVE ASSIST GRIP ASSEMBLY
63339A
37.REMOVE ROOF HEADLINING SERVICE HOLE COVER (w/ Cover)
81260A
38.REMOVE MAP LIGHT ASSEMBLY
73350C
39.SEPARATE REAR CENTER SEAT OUTER BELT ASSEMBLY
Disengage the 2 claws and open the slip joint cover.
Remove the bolt and separate the rear center seat outer belt.
40.REMOVE ROOF HEADLINING ASSEMBLY
| *a | Front Pillar RH Side | *b | Front Pillar LH Side |
| *c | Rear Pillar RH Side | - | - |
for front pillar RH side:
Disconnect the connector
Using a clip remover, remove the 4 clamps.
for front pillar LH side:
Disconnect the connector
Using a clip remover, remove the 4 clamps.
for rear pillar RH side:
Disconnect the connector
Using a clip remover, remove the 3 clamps.
Disengage the 2 claws.
Using a clip remover, remove the 3 clips.
Disengage the 2 hooks.
Remove the roof headlining from the vehicle through the back door as shown in the illustration.
Do not damage the roof headlining assembly or body interior.