The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.
73143
1.INSTALL SEAT BELT HOLE SEAL
Engage the 2 claws to install the seat belt hole seal.
73360
2.INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Check the angle of inclination required to lock the retractor.
| *a | Lock |
| *b | Unlock |
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
Do not disassemble the retractor.
If the operation is not as specified, replace the rear seat 3 point type outer belt assembly.
Engage the 2 hooks to install the rear seat 3 point type outer belt assembly.
Install the bolt.
Install the shoulder anchor part of the rear seat 3 point type belt assembly with the bolt.
Engage the 2 claws and install the floor anchor part of the rear seat 3 point type belt assembly with the bolt.
Check that the ELR locks.
Perform the check with the rear seat 3 point type outer belt assembly installed.
With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the rear seat 3 point type outer belt.
Remove the bolt and disconnect the 2 claws and the floor anchor part of the rear seat 3 point type belt assembly.
62471A
3.INSTALL ROOF SIDE INNER GARNISH
64730B
4.INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
64740C
5.INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
73360
6.CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
62331A
7.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
67917A
8.INSTALL REAR DOOR SCUFF PLATE
58387B
9.INSTALL REAR FLOOR FINISH PLATE
09113
10.INSTALL JACK HANDLE (for RH Side)
81250
11.INSTALL NO. 2 ROOM LIGHT ASSEMBLY (w/ Luggage Compartment Room Light)
64771G
12.INSTALL SPARE WHEEL COVER
58410B
13.INSTALL DECK BOARD ASSEMBLY
14.INSTALL REAR SEAT ASSEMBLY (for Fold Down Seat Type)
15.INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type LH Side)
16.INSTALL REAR SEAT ASSEMBLY (for 60/40 Split Seat Type RH Side)