Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR › 2011.08–2016.09
RM19S0E _58 Vehicle Interior _051497 SEAT BELT _0248349 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:
·

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/ VSC/Built-in Type Yaw Rate Sensor)>PRECAUTION). (w/ Front Seat Side Airbag)

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



NOTICE:

Always use "TORX" socket wrench E10 when removing the front seat.


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION (w/ Front Seat Side Airbag)

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Front Seat Side Airbag)

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


Hide 7.REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

Hide 71511S 8.REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD

a.
B286707

Remove the 2 hog rings.


b.
B272774

Remove the 14 hog rings and the separate type front seat cushion cover from the separate type front seat cushion pad (occupant detection sensor).