The No. 1 heater control sub-assembly (A/C switch, A/C LED) is powered through the A/C fuse. The No. 1 heater control sub-assembly (A/C switch, A/C LED) transmits operational signals of each switch to the air conditioning amplifier assembly.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Remove the No. 1 heater control sub-assembly (A/C switch, A/C LED) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Air Conditioning System)>REMOVAL).
Inspect the No. 1 heater control sub-assembly (A/C switch, A/C LED) (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL(for Manual Air Conditioning System)>INSPECTION).
OK
NG
Disconnect the No. 1 heater control sub-assembly (A/C switch, A/C LED) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| F38-2 (L) - Body ground | Ignition switch off | Below 1 V |
| F38-2 (L) - Body ground | Ignition switch ON | 11 to 14 V |
| *a | Front view of wire harness connector
(to No. 1 Heater Control Sub-Assembly (A/C Switch, A/C LED)) |
OK
NG
Disconnect the F38 No. 1 heater control sub-assembly (A/C switch, A/C LED) connector.
Disconnect the F41 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F38-3 (E) - F41-12 (LED) | Always | Below 1 Ω |
| F38-4 (B) - F41-2 (A/C) | Always | Below 1 Ω |
| F38-3 (E) or F41-12 (LED) - Body ground | Always | 10 kΩ or higher |
| F38-4 (B) or F41-2 (A/C) - Body ground | Always | 10 kΩ or higher |
OK
NG