88625
1.INSTALL NO. 1 COOLER THERMISTOR
88501
2.INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY
If a new cooler evaporator is installed, add compressor oil to the cooler evaporator as follows.
Add 40 cc (1.35 fl. oz.)
ND-OIL 8 or equivalent
Install the cooler evaporator with the cooler thermistor.
Engage the 4 claws and install the lower heater case.
Install the 3 screws.
Engage the clamp and install the connector to the lower heater case.
88539J
3.INSTALL DRAIN COOLER HOSE
Install the drain hose.
88515
4.INSTALL COOLER EXPANSION VALVE
Sufficiently apply compressor oil to 2 new O-rings and the fitting surface of the No. 1 cooler evaporator.
ND-OIL 8 or equivalent
Install the 2 O-rings to the cooler evaporator.
Keep the O-rings and O-ring fitting surfaces clean from dirt or any foreign objects.
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
87107A
5.INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY
Install the radiator heater unit onto the air conditioning unit.
Engage the 3 claws and install the clamp.
88897U
6.INSTALL ASPIRATOR PIPE (for Automatic Air Conditioning System)
Engage the 2 claws and install the aspirator pipe.
87050C
7.INSTALL NO. 1 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Align the reference position, and then install the air conditioning radiator damper servo.
| *a | Reference Position |
Tighten the 2 screws.
87050D
8.INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)
Align the reference position, and then install the air conditioning radiator damper servo.
| *a | Reference Position |
Tighten the 2 screws.
55909A
9.INSTALL AIR MIX DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Engage the 3 claws and install the air mix damper control cable.
Install the plate.
55906A
10.INSTALL DEFROSTER DAMPER CONTROL CABLE SUB-ASSEMBLY (for Manual Air Conditioning System)
Engage the 3 claws and install the defroster damper control cable.