88515
1.INSTALL COOLER EXPANSION VALVE
Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.
ND-OIL8 or equivalent
Install the 2 O-rings onto the cooler evaporator.
Using a 4 mm hexagon wrench, install the cooler expansion valve with the 2 hexagon bolts.
88706A
2.CONNECT LIQUID TUBE SUB-ASSEMBLY A
88707B
3.CONNECT SUCTION TUBE SUB-ASSEMBLY B
Remove the vinyl tape from suction tube and the connecting portion of the unit.
Apply sufficient compressor oil (ND-OIL8) to a new O-ring and the connecting part of the suction tube.
ND-OIL8 or equivalent
Install the O-ring onto the suction tube.
Securely connect the suction tube to the air conditioning unit.
Turn the hook connector in the direction indicated by the arrow in the illustration.
Insert the pipe joints securely into the fitting holes and tighten the bolt.
4. CHARGE REFRIGERANT
5. WARM UP ENGINE
6.INSPECT FOR REFRIGERANT LEAK