76085
1.REMOVE REAR SPOILER SUB-ASSEMBLY (w/ Rear Spoiler)
67751
2.REMOVE BACK DOOR TRIM BOARD
85292A
3.REMOVE REAR WIPER ARM HEAD CAP (w/ Rear Wiper)
4.REMOVE REAR WIPER ARM AND BLADE ASSEMBLY (w/ Rear Wiper)
85110R
5.REMOVE REAR WIPER MOTOR ASSEMBLY (w/ Rear Wiper)
85143R
6.REMOVE REAR WIPER MOTOR GROMMET (w/ Rear Wiper)
67894B
7.REMOVE BACK DOOR PANEL NO. 2 PROTECTOR
67893A
8.REMOVE BACK DOOR PANEL NO. 1 PROTECTOR
Use the same procedure as for the No. 2 side.
68131
9.REMOVE BACK DOOR GLASS
Apply protective tape to the outer surface of the vehicle body to prevent scratches.
| *1 | Protective Tape |
Place matchmarks on the back door glass and vehicle body on the locations indicated in the illustration.
| *a | Mark |
Matchmarks are not necessary if the back door glass is not going to be reused.
Disconnect the 2 connectors.
If the vehicle is equipped with rear window defogger, disconnect the connector.
Pass a piano wire between the vehicle body and glass from the interior.
| *1 | Piano Wire |
Tie both wire ends to wooden blocks or similar objects.
Cut off the adhesive by pulling the piano wire around the back door glass.
When separating the back door glass from the vehicle, be careful not to damage the paint or interior and exterior ornaments.
Using suction cups, disengage the 2 clips and remove the back door glass.
Be careful not to drop the back door glass.
64813B
10.REMOVE BACK WINDOW GLASS ADHESIVE DAM
Using a scraper, remove the back window glass adhesive dam.
Be careful not to damage the back door glass.
Be sure to replace the back window glass adhesive dam with a new one.
64828B
11.REMOVE BACK WINDOW GLASS CLIP LH
Using a scraper, remove the back window glass clip.
Be careful not to damage the back door glass.
Be sure to replace the back window glass clip with a new one.
64827B
12.REMOVE BACK WINDOW GLASS CLIP RH
Using a scraper, remove the back window glass clip.
Be careful not to damage the back door glass.
Be sure to replace the back window glass clip with a new one.