53876A
1.REMOVE FRONT FENDER LINER LH (for LHD)
53875A
2.REMOVE FRONT FENDER LINER RH (for RHD)
Use the same procedures for the LH and RH side (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>FRONT SPEED SENSOR>REMOVAL).
53510
3.REMOVE HOOD LOCK ASSEMBLY
Remove the 3 bolts and the hood lock.
Disconnect the hood lock control cable.
53601
4.REMOVE HOOD LOCK CONTROL LEVER SUB-ASSEMBLY
Disengage the 3 claws and remove the hood lock control lever.
Disconnect the hood lock control cable.
53630
5.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for LHD)
Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.
| *1 | Hood Lock Control Cable | *2 | Clamp |
| *3 | Grommet | - | - |
Pull the hood lock control cable from the engine compartment and remove it.
53630
6.REMOVE HOOD LOCK CONTROL CABLE ASSEMBLY (for RHD)
Using a screwdriver with its tip wrapped in protective tape, disconnect the clamps shown in the illustration.
| *1 | Hood Lock Control Cable | *2 | Clamp |
| *3 | Grommet | - | - |
Pull the hood lock control cable from the engine compartment and remove it.