Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR › 2011.08–2014.07
RM19S0E _59 Vehicle Exterior _051504 WIPER / WASHER _0248406 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  INSTALLATION  


PROCEDURE

Hide 85143R 1.INSTALL REAR WIPER MOTOR GROMMET

a.
E346372

Apply MP grease to the entire surface of the rear wiper motor grommet lip.

HINT:

Make sure that the hole does not get clogged with MP grease and the grooves on the lip are filled with MP grease.


Text in Illustration
V100145

Lip of Rear Wiper Motor Grommet


Hide 85110R 2.INSTALL REAR WIPER MOTOR ASSEMBLY

a.
E221589E03
1.677,1.969 1.813,2.115 0.135,0.146 10 true 1 0.719,0.438 0.844,0.594 0.125,0.156 10 true 2 2.479,1.427 2.604,1.594 0.125,0.167 10 true 3

Install the rear wiper motor with the 3 bolts in the order shown in the illustration.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Connect the connector.


Hide 3.INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

a.
E146589E14
0.792,3.604 0.792,3.979 false 1.927,3.375 2.365,3.135 false 1.083,1.844 1.531,1.604 false 0.917,1.76 1.135,1.979 0.219,0.219 10 false *a 0.719,4 0.948,4.229 0.229,0.229 10 false *1 2.385,3.031 2.573,3.208 0.188,0.177 10 false *b

Operate the wiper and stop the rear wiper motor at the automatic stop position.


b.

Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).


c.

Clean the wiper pivot serrations with a wire brush.

Text in Illustration
*1 Wire Brush
*a Wiper Arm Serration
*b Wiper Pivot Serration


d.
E221562E01
0.529,0.954 0.688,1.113 0.159,0.159 10 *a 0.717,1.049 0.942,1.372 false

Install the rear wiper arm and blade with the nut to the position as shown in the illustration.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

HINT:

Hold the arm hinge by hand while tightening the nut.


Text in Illustration
*a Mark for Blade Position


e.

Operate the rear wiper while spraying washer fluid on the glass. Make sure that the rear wiper functions properly and there is no interference with the vehicle body.


Hide 85292A 4.INSTALL REAR WIPER ARM HEAD CAP

a.

Engage the 2 claws and 2 hinges, and install the rear wiper arm head cap.

HINT:

Push down on the cap until a click sound can be heard.



Hide 67751 5.INSTALL BACK DOOR TRIM BOARD