Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM › 2011.08–2014.07
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248415 LIGHTING SYSTEM J

LIGHTING (EXT)  LIGHTING SYSTEM  Front Fog Light Circuit  


DESCRIPTION

The main body ECU controls the FR FOG relay.

WIRING DIAGRAM

E231528E01
4.123,2.029 4.444,2.185 0.320,0.156 10 TAIL 4.627,1.84 5.444,1.998 0.817,0.158 10 TAIL NO. 2 3.586,3.257 4.157,3.411 0.572,0.154 10 FOG FR 4.342,3.429 4.913,3.581 0.572,0.153 10 FOG FR 5.893,1.299 6.267,1.458 0.374,0.160 10 TRLY 2.851,1.123 2.963,1.295 0.112,0.173 10 1 2.811,1.304 3.003,1.454 0.192,0.150 10 3F 2.522,1.123 2.625,1.295 0.103,0.173 10 1 2.818,1.522 2.995,1.694 0.177,0.173 10 *2 2.484,1.522 2.662,1.694 0.177,0.173 10 *1 2.47,1.297 2.676,1.461 0.206,0.164 10 3E 2.855,3.465 2.959,3.638 0.103,0.173 10 7 2.804,3.653 3.010,3.810 0.206,0.157 10 3C 5.59,1.103 5.771,1.275 0.181,0.173 10 14 5.891,2.697 6.315,2.843 0.425,0.146 10 FFGO 5.588,2.509 5.773,2.681 0.185,0.173 10 13 5.561,2.696 5.799,2.844 0.238,0.148 10 MB 0.956,1.295 1.752,1.462 0.796,0.167 10 from Battery 1.718,4.482 2.436,4.650 0.718,0.168 10 *1: for LHD 1.718,4.792 2.459,4.956 0.741,0.163 10 *2: for RHD 3.709,4.133 5.334,4.467 1.625,0.334 10 Instrument Panel Junction Block Assembly 0.956,3.656 1.758,3.820 0.802,0.164 10 to Fog Light 5.752,4.827 6.759,4.991 1.007,0.164 10 Main Body ECU 5.561,1.305 5.799,1.453 0.238,0.148 10 MB

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Front Fog Light Relay Front Fog light relay OFF or ON Light Control switch is in TAIL or HEAD position

OK:

FOG FR relay operates. (Fog lights illuminate.)




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.REPLACE MAIN BODY ECU
2.REPLACE MAIN BODY ECU
a.


NEXT

3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
3.PERFORM ACTIVE TEST USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Active Test.


e.

According to the display on the intelligent tester, perform the Active Test.

Main Body
Tester Display Test Part Control Range Diagnostic Note
Front Fog Light Relay Front Fog light relay OFF or ON Light Control switch is in TAIL or HEAD position

OK:

FOG FR relay operates. (Fog lights illuminate.)




OK

END (MAIN BODY ECU WAS DEFECTIVE)

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY