Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH
RM19S0E _59 Vehicle Exterior _051505 LIGHTING (EXT) _0248424 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


PROCEDURE

Hide 84340 1.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E167768

Insert the stop light switch assembly until the rod hits the pedal.

HINT:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E167769

Make a quarter turn clockwise to install the stop light switch assembly.

HINT:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.


Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less



c.

Check the protrusion of the rod.

Protrusion of the rod:

0.5 to 2.6 mm (0.020 to 0.102 in.)



d.

Connect the connector.


Hide 55606 2.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY